Install Woder 10K-Gen2

The Woder® 10K-GenII comes with everything you need. The easy installation takes just minutes. No plumbing tools or know-how needed. It has never been easier to learn how to install Woder® 10K-GenII. The Woder® 10K-GenII comes as a complete assembled kit and includes: Filter, Head with a built-in valve, inlet hose – 3/8 female compression by 1/4 standard pipe thread, outlet hose- 3/8 m compression by 1/4 standard pipe. Replacement filters available here.

How to install the Woder® 10K-GenII :

Start by turning off the cold water supply to your sinks’ faucet.

Disconnect the existing hose from the supply valve.

Connect the inlet hose to the valve. The inlet hose is on the left side of the Woder 10K GenII. Hand tighten, and then give a ¼ turn with a wrench or pliers.

Then connect the outlet hose of the filter to the faucet hose, and tighten.

Secure the bracket and filter to a convenient location under the sink.

Turn the cold water supply valve back on.

In order to activate the filter, turn on the cold water faucet, and let it run for three minutes, or until the water runs clear.

To replace the filter, simply unscrew it from the bracket, and screw on the new filter.

And you’re done!

Now you know how to install Woder® 10K-GenII !

Please note: TDS meters (or PPM) are not an effective to way to check this filter and not an effective to way to check or test water. TDS meter are known to also pick up ions. The filter formula is bacteriostatic. The way bacteriostasis is accomplished is by ion transfer and sharing electrons with any pathogen captured by the filter. Essential minerals are also picked up by TDS meters.