Install Woder 10K-DC

The Woder 10K under sink water filter comes with everything you need. The easy installation takes just minutes. No plumbing tools or know-how needed. It has never been easier to learn how to install under sink water filter.

Woder® 10K comes as a complete assembled kit. Includes: Filter body, inlet hose – 3/8 female compression by 1/4 standard pipe thread, outlet hose- 3/8 male compression by 1/4 standard pipe, clip and screw.

How to install the Woder 10K Under sink Filter:

First, turn off the water supply to your sink and disconnect the existing hose from the cold water supply valve.

Connect the inlet hose of the Woder 10K under sink water filter to the valve and connect the outlet hose of the filter to the faucet hose.

Secure the supplied bracket in a convenient location under the sink.

Snap the filter into the bracket.

And turn the cold water supply valve back on.

In order to activate the filter, turn on the cold water faucet and let it run for 3 minutes, or until the water runs clear. Please note: Only 15% of the filters gets the ‘black wash’ as shown on the video below. Either way, you have received a brand new Woder Filter!!

And you’re done!

…Well, now you know how to install under sink water filter of Woder!

Please note: TDS meters (or PPM) are not an effective to way to check this filter and not an effective to way to check or test water. TDS meter are known to also pick up ions. The filter formula is bacteriostatic. The way bacteriostasis is accomplished is by ion transfer and sharing electrons with any pathogen captured by the filter. Essential minerals are also picked up by TDS meters.